problem!
Up to Link G2/G3 Engine Management
GOOD MORNING!
i've a link g3 ecu on my car and my problem is that: with the old pc which has windows xp i can have communication to the LINk ECU! With my new pc which has windows 7 i can not have communicatios to the link ecu.Ihave downloaded the PC LINK V3.40(BUILD 1) and the G2/G3 help for vista and windows 7 but still i have the problem with the communication! My new pc has fuctional system 64-bit! Is that the problem? THANK YOU!
I've downloaded the new version of G4 software and it recognizes the ecu of G3 as a unknown object but when i tried the version v3.40 again, it worked ! The problem was that the version v3.40 didn't had the usb drivers to have communication to the ecu of G3. Now it works fine! THANKS A LOT Stevieturbo!!!!!!!
Just for a bit of info.
To run the G4 PCLink successfully, requires the G3 system to be updated with G4 firmware. There is an additional cost to get this updated, but you can do it yourself. Just email sales@linkecu.com for more info if ever needed. You are dead right about the drivers, I think it is Link USB v6.1 drivers needed from memory.
Jurgen
