Skip to content. | Skip to navigation

Personal tools
Log in
Sections
You are here: Home › Forums › Link G1 Forum › Connect Innovate MTX-L to Link ECU G1

Connect Innovate MTX-L to Link ECU G1

Up to Link G1 Forum

Connect Innovate MTX-L to Link ECU G1

Posted by Sanford Edinberry at January 25. 2012

Hi All,

Can I connect Innovate MTX-L to Link ECU G1 directly as there are two analogue outputs from the MTX...Is this possible?

Thanks SanMan

Re: Connect Innovate MTX-L to Link ECU G1

Posted by Scott at January 30. 2012

Hi SanMan,

Yes, it is possible to connect the Innovate analogue outputs to your G1 ECU. The catch is that the G1 was not configured to run wideband O2 sensors, so you will need to tell the Innovate to use simulated narrowband mode. Then select the analogue input in your G1 ECU as narrowband.

Scott.

Powered by Ploneboard
Document Actions
Portlet ECU red Xtreme image

Xtreme

Our most powerful engine management system ever, equals or betters any ECU on the market.  Whatever the application, the Xtreme's advanced configurability enables today's complex engines to be optimised.

Read More

Link Engines

Plug-In

Free yourself from the constraints of the factory ECU. Link's G4 Plug-Ins fit discretely inside the original enclosure. Installation is a breeze, no alteration of the factory wiring loom required. An XS connector provides additional inputs and outputs such as oil pressure inputs or anti-lag / logging switches (the number available depends on the application).

Read More