Skip to content. | Skip to navigation

Personal tools
Log in
Sections
You are here: Home › Forums › Link G4 Engine Management › 4x4 with g4

4x4 with g4

Up to Link G4 Engine Management

4x4 with g4

Posted by abd al darweesh at February 19. 2011
hi everybody . i have nissan r32 it's all wheel . and I have g4 xtreme . can anyone tell me what i have to do for the four wheel wiring and setting . thanks.

Re: 4x4 with g4

Posted by dobsons dyno tune at May 06. 2011

you will need to send a tps signal to the 4wd ecu to make it work correctly

where are you from i have done many of these

drop me a email dobson99@xtra.co.nz

Re: 4x4 with g4

Posted by abd al darweesh at January 18. 2012

hi.

i am from saudi arabya

 Unfortunately, the answer to your question late
You must be said that the tps wire to the 4wd computer

But I have seen in the map in the factory wiring daigram that there are three wires wires

1-is rpm wire

2-tps (-)

3-tps(+)

The problem is that the positive terminal of the third cycle where you get it .can i take it from Auxiliary Outputs.

or  do theye mean tps (+) 0-5v

pleas help me if you can Thanks again

best regards

Re: 4x4 with g4

Posted by Simon (Link Staff) at January 19. 2012

RPM input can be a tacho out from the ECU it will be ok to share this.

TPS (-)  I suspect will be a signal ground.

TPS + would be the signal.

Re: 4x4 with g4

Posted by abd al darweesh at January 23. 2012

hi simon ,

thank you for responding to my stupid question  and I appreciate for that.

i did it and it is working fin .this is the dayno  .

best regards

 

Attachments
Powered by Ploneboard
Document Actions
Portlet ECU red Xtreme image

Xtreme

Our most powerful engine management system ever, equals or betters any ECU on the market.  Whatever the application, the Xtreme's advanced configurability enables today's complex engines to be optimised.

Read More

Link Engines

Plug-In

Free yourself from the constraints of the factory ECU. Link's G4 Plug-Ins fit discretely inside the original enclosure. Installation is a breeze, no alteration of the factory wiring loom required. An XS connector provides additional inputs and outputs such as oil pressure inputs or anti-lag / logging switches (the number available depends on the application).

Read More